I am Zac, I have ran my Accord for over 2 years. I actually like manual work. I'm also when recovering my Honda Accord. At that time of the installment, I made an improvement of the performance on the headlight housing. The initial step was to get a set of Q5 Bi-Xenon link projectors from exactly what I purchased 2 weeks ago.
I started with modification the light bottom with HeartRay D2S 5500K HID bulb which I upgraded in the projector. The manufacturing facility 8th-generation Accord made use of D2 HID bulb and Mitsubishi ballast. Handled to open the housing, took all components away: reflector, bulbs, shroud, mask ... I continued to gauge three points to make sure the Q5 projector is totally lined up with the holes. I pierced the holes with D2 guard, this is the picture I made it done. Ok, I got it, then it has to install projector on the internal with screws and also nuts. It is very important to evaluate the cutoff line before mounting the housing. The line should be straight as well as in a proper placement. When whatever is right, I mounted all up into my Accord. Examine the light again for the placement. I was so thrilled completed these up. After my DIY retrofit for Q5, I have far better exposure over short and medium range, the low-beam cutoff being the only point that makes them less helpful over lengthy array.
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2019
Categories |